Blog

Blog

Company News

2024/12/05

Popularization of professional knowledge on disassembly and assembly methods for routine maintenance of imported bearings

Popularization of professional knowledge on disassembly and assembly methods for routine maintenance of imported bearings

The disassembly and assembly of imported bearings is carried out during regular inspections and replacement of bearings. After disassembly, if the bearing is used again or the condition of the bearing needs to be checked, its disassembly and installation should be the same as before. Pay attention to the fact that the bearing parts are not damaged, especially the difficulty of the replacement operation of the bearing assembly.

2024/12/05

FAG imported bearing seat seal failure reasons and improvement solutions

FAG imported bearing seat seal failure reasons and improvement solutions

The FAG imported bearing seat seal improvement plan "multi-stage pressure relief sealing technology" experimental bearing seat seal ring can reduce the lubricating oil leakage by reducing the pressure difference at both ends of the seal in a working environment without large-scale disassembly such as shaft extraction, and at the same time, the residual leaked lubricating oil flows back to the oil tank to achieve the purpose of shaft seal leakage prevention.

2024/12/05

Three methods to find SKF bearing faults

Three methods to find SKF bearing faults

SKF bearings may have one or another fault during operation. After the fault occurs, we need to find out the cause of the fault to prevent similar faults from happening again in the future. So what are the methods for finding faults after a fault? Let's take a look at them together.

2022/07/28

How to check whether the imported bearing grease is mildewed

How to check whether the imported bearing grease is mildewed

In a sunny life, use a screwdriver to remove the grease, and then fly to 45 degrees. Compared with the sun, observe the droplet condition. In the sun, you can clearly see that there is no debris in the grease is the best, and it can work again. When there are too many debris, the grease must be replaced.

2022/01/10

Popularization of professional knowledge on disassembly and assembly methods for routine maintenance of imported bearings

Popularization of professional knowledge on disassembly and assembly methods for routine maintenance of imported bearings

Popularization of knowledge on disassembly and assembly methods for routine maintenance of imported bearings

2021/11/12

Several factors in selecting bearing types

Several factors in selecting bearing types

The bearing that mainly bears radial load is the radial bearing. The nominal contact angle of this type of bearing is a0<=45 0="" br="">N-type and NU-type cylindrical roller bearings can only bear radial loads, and other types of radial bearings can bear both radial loads and axial loads.

< 12 >